Brass wire drawing and online annealing

Hello,

I intend to cast brass in various grades at a diameter of 3/8" and finish to about 1/8". I would like to resistance anneal this wire and drop coil. Does any one have experience on this process? Most of the people draw copper only.

I would like to buy the required equipment for drawing and annealing this wire.

Hello Kamkat,

Here is the information you are looking for:

Your SAMP contact for India

SAMP - Division Sampsistemi - Non ferrous
Via Calzoni, 2 - 40128 Bologna - Italy
Alessandro Spagnuolo
Tel. + 39 051 6319 411
Fax + 39 051 35 67 50

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Web: www.sampsistemi.com/


Your Niehoff contact for India

Niehoff of India Pvt. Ltd.
47/48 KM, Hyderabad-Mumbai National Highway
Hyderabad, India 502285
Tel: 91-8455-231-729
Fax: 91-8455-231-629

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Web: www.niehoff-gmbh.info/

Sincerely,
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com

hanks for the reply vettecoupe, in the mean while some replies from people who have had some experience with the above subject could share the same , that would really help .

regards

kamal